Frame is intended for installation of data and telecommunication devices and their distribution systems.
There is one M8 screw placed at the side wall of the frame to connect the bonding.
The blanking panel is on the rear side of the frame.
the cabinet is not intended for outdoor installations and for installations in environment that can negatively influence the functionality of the cabinet and the mounted devices (e.g. environment with danger of explosion or humid and wet surroundings).
Must be protected against
a different usage than the cabinet is intended for.
Improper handling is especially
overloading (exceeding the maximum recommended load),
device installation that can negatively influence the operation and function of the cabinet or the installed equipment,
change of the construction or design of the cabinet.
Installation of the cabinet
To ensure the maximum recommended load, it is necessary to distribute the load evenly.
Place the cabinet on a flat floor and adjust any differences using levelling feet.
To avoid dust penetration in case the cables lead through some of the cable openings, it is possible to sealed it using a blanking panel with a brush and equip it with a hem edge (both are included in the supply).
All parts are made of recyclable materials and after decommissioning the cabinet, they must be disposed of according to relevant regulations.
Certificate and conformity
This product is fully in accordance with ČSN EN 62208 ed.2:2012.